Audio Authority Series 1500 Installation Guide download pdf (Page 14)

Using the 1550A Installer Setup Tool

System Calibration and Setup

The Model 1550A is a display that shows the setup menus and settings for

Series 1500 Intercom Systems. See page 18 for a menu map and default

values. The entire system can be calibrated from one Counter Station.

Connect the 1550A Setup Tool to the RJ45 jack on the underside of any live

Counter Station. (The jack is at an angle.)

Basic Setup Procedure

• Hold the SETUP key on the Counter Station for one second to enter Setup Mode. The 1550A displays: “SERIES 1500

EQUIPMENT CALIBRATION PLATFORM”.

• To navigate the menus, use the VOLUME UP and VOLUME DOWN keys to move the cursor.

• Touch SETUP to enter a submenu or conrm a selection, and PRIVACY to go back.

• Any changes you make are recorded as you exit each submenu. When you exit Setup Mode, you must choose to

either save all changes and exit or exit without saving.

• If you need to re-enter Setup Mode, simply press SETUP for one second.

Power User Tips

• For faster menu navigation, submenus may be selected by touching the key that is lit RED corresponding to the menu

item (see the numbered keys above). For instance, to enter BLOWER MOTOR DELAY, press 1 and then 1.

• See page 18 for a menu map and default values.

• To Exit Setup Mode from any menu, hold SETUP for one second and follow the prompts on the 1550A.

• After adjusting a Lane Station or Counter Station, you can use the CAMERA UP or CAMERA DOWN keys to select

other stations for adjustment without leaving the submenu.

SD Card Installation Notes

Series 1500 SD cards have two uses: Storing intercom conguration data and upgrading the intercom system rmware.

• Storing the conguration of the intercom system for later retrieval or programming another system is the primary

use for the SD card. This can save time from one installation to the next if the installations are similar. The system

settings can also be retrieved from the memory card in case of a system upgrade or equipment replacement.

• To store conguration data on the memory card, insert the card into the hub and perform a WRITE TO MEM.CARD

operation in the SETUP menu (see page 15). Then remove the card and store it onsite in a safe, designated location.

In the same manner, write the conguration data to an additional SD card if copying the settings to another system is

desired.

• To load a conguration from the memory card, insert the card into the hub and perform a READ FROM MEM.CARD

operation in the SETUP menu (see page 18).

NOTE: It is NOT necessary that the SD memory card remain in the hub during normal operation.

VOLUME = Move menu

cursor up and down

1234

5678

9 10 11 12

13 14 15 16

SETUP = Enter

or Confirm

PRIVACY = Go Back to

previous menu

CAMERA = Select next

or previous Lane

or Counter Station

(after selecting a single

Lane or Counter Station)

Intercom Setup Tool • Model 1550A

RECESSED

JACK

(ANGLED)

CAT 5E/6

1500A COUNTER STATION (UNDERSIDE)

1550A SETUP TOOL

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Audio Authority Series 1500 Installation Guide Page 14

Comments to this Manuals

Related products and manuals for Door intercom systems Audio Authority Series 1500